SunSDR2DX with control panel

Transceiver with a control panel.

The bundle includes a SunSDR2DX transceiver and an E-Coder2 control panel. The main specifications below refer to the transceiver.

HF
100W
ADC
16bit
In bundle
2pcs
6 m
80W

Transceiver features

100 W and a DDC/DUC architecture

  • Direct sampling on receive (DDC) and direct digital synthesis on transmit (DUC), with separate receive and transmit paths.
  • 16-bit LTC2209 ADC with a 160 MHz sampling rate.
  • A quiet 140 × 140 mm fan and stable operation through long transmit cycles on digital modes.

Two independent receivers

  • Two software receivers, each with a sub-receiver; reception 0.1–65 and 95–155 MHz.
  • Panorama up to 312 kHz and a band scope up to 80 MHz.
  • Simultaneous reception on different HF bands and split operation. Use the appropriate connection diagram for a contest setup with peripherals controlled over ExtCtrl.

Control panel

The panel has a main tuning encoder with 1024 PPR resolution, 14 programmable buttons with templates for 72 functions, and 3 programmable rotary encoders with push-button functions. It connects via USB and supports macOS, Windows and Linux.

Audio and monitoring

E-Coder2 is a new-generation control panel with a built-in 24-bit audio codec and a dynamic range of 114 dB (CS4272).

When you operate in RX mode, the ExpertSDR2/3 sends the same audio stream in the TRX and in the E-Coder2. Thus, you can listen to the air directly from the TRX or from the E-Coder2, the latency in both cases is the same - almost nonexistent. Also, in E-Coder2 we've implemented a special CW core to minimize latency if you monitor yourself during transmission.

E-Coder2 control panel

Remote operation

E-Coder2 is especially useful for users of remote-control systems or those operating some distance from the transceiver.

Connections and power

The USB port must provide 5 V and at least 0.5 A. The rear panel has four 6.3 mm stereo jacks: headphones, an unbalanced microphone, a CW key and a PTT footswitch.

ExpertSDR3, TCI and ERS

Free ExpertSDR3 with free updates. The open TCI protocol connects loggers, skimmers and digital-mode programs without virtual COM ports or audio cables; programs without TCI use the RadioSync bridge (CAT, OmniRig). Expert Remote System (ERS) is included: control from a browser or ExpertSDR3, directly or through the ExpertCloud service.

About the software
  • ExpertSDR3Free software for operating on the air
  • TCIAn open protocol for loggers, skimmers and digital modes
  • ERSRemote operation from a browser or ExpertSDR3

Hardware section

  • ALC*

    Input for external power amplifiers; today control runs over ExtCtrl.

  • Full Duplex*

    Full-duplex operation.

  • Predistortion*

    Predistortion for a clean signal without external devices.

* The hardware is ready; software support is planned in ExpertSDR3 updates.

SpecificationsSunSDR2DX with control panel

Receiver Characteristics

Receiver Characteristics
RF ADC, resolution16 bit
RF ADC, sampling rate160 MHz
ADC typeLTC2209
RX Frequency range0.1...65; 95...155 MHz
Sub-receivers2 pcs
Sample rate39; 78; 156; 312 @ 24 kHz / bit

See all specifications for details

SunSDR2DX — Antennas and receive input
SunSDR2DX — Antennas and receive input

Transmitter Characteristics

Transmitter Characteristics
RF DAC, resolution14 bit
RF DAC, sampling rate640 MHz
TX Frequency range160-6; 2 m
Output power on HF100 W
Output power on 6M80 W
Output power on VHF7-8 W

See all specifications for details

SunSDR2DX — Transmit path
SunSDR2DX — Transmit path

Specifications

Specifications
Built-in audio codec / Dynamic Range24 / 114 bit/dB
RF input/output2 HF, 1 VHF (Mini_UHF), ADC IN, DAC OUT (SMA)
DC voltage range in RX/TX8...14.8 / 10...14.8 V
Recommended DC voltage13.8 V
Current consumption RX/TX1.2 / 24 A
Power consumption RX/TX16.5 / 330 W

See all specifications for details

SunSDR2DX — Power, network and external devices
SunSDR2DX — Power, network and external devices

Documentation and package contents

Expert Electronics

We design and manufacture SDR transceivers, receivers and software for radio amateurs.

    © 2026 Expert Group. All rights reserved.